Before You Begin
This lesson begins assuming Adjusted Attendance Rate has been enabled. If not, visit Enable Adjusted Attendance Rate.
Required Permission: Manage Attendance Configuration
Where to Start
- Go to System Configuration.
- Select Attendance.
- Go to Rate Adjustment.
- Create a New Rate Adjustment.
- Enter the Starting Value.
- Enter the End Value.
- Enter the Adjusted Value (any value within the start and end value of the rate adjustment will be changed to this new value).
- Select Save
Most numbers on the extracted file will be 0, 0.5, and 1. However, there may be some SISs that report 0, 0.25, 0.50, 0.75, and 1. Regardless of the extract, districts will tend to focus on 0, 0.5, and 1. These are the numbers districts will enter within eduCLIMBER using the Adjusted Attendance Rate.
Example: When 0-0.49 is found on the extract, show 0 in eduCLIMBER. When 0.5-1 is found on the extract, show 1 in eduCLIMBER.